AIDA IPCOMM-POE Wireless Streaming Device

FEATURES
• Give any IP based camera wireless functionality to submit video or
control over most WiFi based routers/networks.
• PoE+ injector to power any IP camera connected to (if supported)
• Capability of using DC12V power tap, or a NPF battery series to
power the camera without use of DC12V port.
• Bottom of the IPCOMM-PoE has 3 1/4-20” mounting holes for perfect
fitment
• Provides a wireless solution to hard-to-reach or unmountable camera
setups in any workflow.
• Can be paired with multiple IPCOMM-PoE’s for multi-cam workflows.

• Performance based off of overall bitrate, not resolution. Keep in mind
of these rules:
1.Limit the amount of obstacles between the router and IPCOMM-POE
2. Ensure the signal strength seen when setting the IPCOMM-POE up is
above 60%
3. Ensure the bandwidth sent by the camera to the router is within
2Kbps~50kbps, this mostly depends on your signal strength. Anything higher
will cause delay and video rupturing.
4. To avoid power loss, plug in DC12V to keep IPCOMM-PoE running, anda
swap batteries if needed.

Join the Wireless Revolution!

Let's face it. Wireless transmission has never been the solution to live streaming.. That was until the IPCOMM-POE
came along.

With the power to inject PoE+ power into any camera via DC12V or an NPF-Battery (not included), you can easily
take your video creations wirelessly onto any Wi-Fi router, sending IP video or IP control flawlessly as far as your router can reach!

This solution brings a whole new level of broadcasting opportunity for on-the-go, non-mounting solutions! So bring
on this revolution, and start streaming wireless today!